Description

This documents explains Cordless scanner Gryphon 4100 Series Prefix/Sufix setup.

 

Prefix/Sufix setup:

  • If less than the expected string of 20 characters are selected, scan the ENTER/EXIT barcode

        to terminate the string.

  • Scan the ENTER/EXIT barcode once again to exit Programming Mode.
  • The resulting message string would appear as follows:

        Scanned barcode data:12345
        Resulting message string output: $12345

This option sets up to 20 characters each from the set of ASCII characters or any hex value from
00 to FF.
To configure this feature, scan the ENTER/EXIT barcode to place the unit in
Programming Mode, then the “Set Global Prefix” or “Set Global Suffix,” barcode followed by
the digits (in hex) from the Alphanumeric characters in Appendix E, Keypad representing your
desired character(s).

If less than the expected string of 20 characters are selected, scan the
ENTER/EXIT barcode to terminate the string. Reference the section, "Example: Setting a
Prefix"on page 108, for more information.

Exit programming mode by scanning the ENTER/EXIT barcode once again.
 

Related Information

Attached pdf file

suffixset-gryphon.pdf